![]() ![]() Underlayment (must be durable and watertight). ![]() The following tools and materials will assist you in the installation of the standing seam metal roof: As a general rule of thumb, without going up on the roof, you can take the width of your home in feet, multiply this number by 12 and divide the result by 16.Īssuming each panel is 16 inches wide, this will tell you how many panels you need for installation on each side of your home. Once you have the roof measurements, you’ll know how many panels are required for the installation. The typical standing seam drip edge extends 1 inch beyond the eave, and then it gets bent back by an inch. These extra 2 inches will later form the drip edge hem, so it’s important to have this extra length for each panel. You need to measure the vertical run from the eave of the roof all the way to the ridge line and then add in another extra two inches. Each measurement needs to be exact to the inch. You need to take special note here: if the panels are too short, they will be unusable, so you must measure them carefully. You will need to measure your roof – including every eave, gable, ridge, valley and side wall – in order to ensure that you buy the right size roof panels. Not only that, but also the granular surface of the asphalt shingles can rub up against the metal panels, potentially causing them to rust from underneath. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |